Washer

E22 - Fill Timeout: This occurs when the washer takes over 8 minutes to fill. Ensure that the water supply valves are fully open, check for kinks or blockages in the inlet hoses, and inspect the water valve screens. If unresolved, consider replacing the solenoid water valve.

E23 - Flood Protect Drain: Triggered by the foam switch closing while idle. Check for issues with water valve functions and the pressure switch foam contacts. An off-balance load might also cause this error, so retry the cycle before replacing components.

E30 - Drain Pump Not Present: Indicates no electrical signal from the drain pump. Check the drain pump's functionality and connections, ensuring it isn't open or stalled.

E31 - Drain Timeout: This occurs with slow draining, suggesting a clogged pump or overly high drain setup. Ensure there are no restrictions and the drain height is appropriate.

E38 to E39 - Dispenser Errors: Occur when the correct reservoir isn't detected or no switches are found within 45 seconds. Check the dispenser functionality without unplugging any connectors unless replacing.

E42 to E49 - Drive Motor and Inverter Errors: These range from excessive current draw to overheating, suggesting checks on the motor functions, cooling measures, and potentially replacing the inverter if issues recur.

E4A to E4C - Voltage Errors: Relate to under or over voltage in the DC bus of the inverter. If these errors occur, check motor functions and consider replacing the inverter.

E4E - EEPROM Fault: Indicates a non-recoverable EEPROM reading error, requiring a replacement of the inverter control board.

E52 to E54 - Communication and Control Failures: Involve lost or failing communications between controls and motors. Ensure all connections are secure and consider replacing the inverter or main control board if the issue persists.

E57 to E60 - Door Lock and Switch Failures: These errors relate to failures in the door locking mechanism during various operational phases. Check door lock switches, solenoid, and main control connections, replacing parts as necessary.

E62 - System Contact Failure: Detected when a shorted component causes a load failure. Inspect and replace wiring or faulty components as required.

E63 to E64 - Unexpected Open Door Errors: Occur when the door unexpectedly opens during operation or wake-up. Verify door lock functionality and connections.

E65 to E67 - Water Sensor Errors: These errors suggest problems with the water level or temperature sensors. Check sensor functionality, wiring, and replace if needed.

E70 to E71 - Key and Control Panel Errors: Indicate stuck or faulty keys. Perform tests to isolate the issue, clean any foreign debris affecting key functions, and replace the control panel or main control if necessary.