Dishwasher

E:01 - Internal Fault: This error indicates a potential issue with internal connections or the power module, which may need a system check or replacement if problems persist.

E:02 - Heating Issues: Displayed when the dishwasher is unable to heat water or activate the zeolite drying system, suggesting possible faults with heaters or relays.

E:03 - Temperature Overload: Signals overheating at main connections, necessitating replacement of the power module and power cord.

E:04 - Heater Malfunction: Indicates problems with either the water or zeolite heater, potentially involving the safety relay on the power module.

E:05 - Water Switch Error: Appears when the water switch motor runs continuously, likely requiring a power module replacement.

E:06 - Door Sensor Fault: This error involves the Hall sensor, which may need checking or replacing if the sensor's voltage is normal but problems persist.

E:07 - Zeolite System Heating Fault: This code is shown when there are issues with the fan or wiring in the zeolite drying system.

E:08 - Low Water Level: Suggests that the heat pump is detecting a lower than expected water level, possibly due to overturned dishes or a leaking valve.

E:09 - Heating Circuit Issue: Indicates interruptions in the heating circuit, advising checks on heater resistance and water hardness settings.

E:10 - Zeolite Heater Circuit Fault: Shown when there's an interruption in the zeolite heater circuit, necessitating checks on resistance and wiring.

E:11 - NTC Sensor Fault: Indicates that NTC resistance values are out of the permitted range, likely requiring checks on wires or plugs.

E:12 - Heating Element Issue: This error is displayed when the heating element is calcified, suggesting a need to descale the appliance and adjust water softener settings.

E:13 - High Water Temperature: Indicates that the water temperature exceeds safe limits, which is a protective measure rather than a fault.

E:22 - Drain Pump Fault: Displayed when the drain pump fails to remove residual water, possibly due to dirty filters or a blocked non-return valve.

E:23 - Drain Pump Circuit Issue: Suggests an open circuit in the drain pump or incorrect resistance values, necessitating wire and plug checks.

E:24 - Draining Issue: Indicates that the non-return valve is not closing properly or that draining is obstructed.

E:25 - Blocked Drain Pump: This error appears when the drain pump is blocked, requiring clearing of foreign objects and securing of the drain pump cover.

E:26 - Water Switch Malfunction: Displayed when the water switch is permanently activated, advising checks on wiring and mains voltage at the motor.

E:27 - Undervoltage Fault: Indicates continuous low mains voltage, which is not a fault with the appliance itself.

E:28 - AquaSensor Fault: Suggests a problem with the AquaSensor, which may not be equipped or could be dirty.

E:29 - Voltage Error: This error is shown when there is either under or overvoltage, affecting the appliance's function and cycle duration.

E:30 - Appliance Overvoltage: Indicates that the appliance has shut off due to excessive voltage, not a fault of the appliance.

E:31 - Zeolite Water Sensor Fault: Shown when there's a fault in the water sensor within the zeolite heater, possibly requiring replacement of the zeolite heater and container.